SIMPA NS11RM - Specifications

17
Specifications
This appliance complies with Electrical Products (Safety) Regulation of Hong Kong.
Model NS11RM
Basic
Specification
Water Heater Type Fan Draught Room-sealed
Flue Type Back Flue
Dimension（mm） 300 (W) x 590 (H) x 155 (D)
Weight（kg） 12
Gas Type Hong Kong Town Gas
Gas Supply Pressure（kPa） 1.5
Connection
Gas G 3/4
Cold Water R 1/2
Hot Water R 1/2
Power Supply AC220 V / 50 Hz
Flue Connection Ø110 x Ø75
Ignition Automatic electronic spark
Rated Heat Input
Maximum (kW)
26.7
Minimum (kW) 4.8
Electrical Consumption (W)
47
Hot Water Capacity ( liter/min )
11
Min. Hot Water Volume（L/min） 2.4
Min. Operating Water Pressure（kPa） 10
Recommended Water Supply Pressure（kPa） 70 ~ 700
Safety Device
Flame Failure Device Flame Rod
Water Flow Checking Device Water Flow Sensor
Remaining Flame Protection Device Bi-metal Switch（90℃）
Over Current Protection Device Fuse（5A）
Over Pressure Protection Device Pressure Relief Valve ( ON : 1.9 Mpa )
Combustion Fan Checking Device Speed Detection Sensor
Heat Exchanger Overheat Pr
otection Device Thermal Fuse（139℃）
Anti-Boiling Protection Device Thermistor（85℃）
Electricity Leakage ELCB
Water Proof IPX4