7
Check the appliance by following step ❶ to ❺.
Caution
• When using the appliance for the first time or in the morning, the burner may not be
ignited instantly because there may be some air remained inside the gas pipe. Please
turn off the hot water tap and wait for 10 seconds, then turn on the hot water tap again
to repeat the auto-ignition process.
• To prevent scalding:
• check water temperature with hand first before taking shower.
Do not direct hot water onto the head or body directly.
• After using high-temperature hot water, the high-temperature
hot water still remains inside the water pipework. To use hot
water again, check the temperature with hand first and wait
for suitable temperature before use.
Check water
temperature with
hand first
• In case of high water supply pressure, relatively loud sound of water flow may occur
during the operation of appliance. This is a normal phenomenon.
• Turn off the cold water valve and the gas supply valve of appliance when it is not used
for a long period of time.
First Time Usage of Appliance
❶
Fully turn on the cold water supply valve.
❷
Turn on the hot water tap, and check if water is running
and close tap.
❸
Fully open the gas valve.
❹
Insert the batteries.
Method: Battery box is located at the bottom of appliance
body. Follow the icons of positive and negative terminals
direction inside the box to insert the batteries (2 pieces of
1.5V D-size alkaline batteries).
❺
Set the flame control and water temperature control
knobs at the knob icon location with “Small Flame (小火)”
and “Low (低)” respectively. Fully turn on the hot water
tap and turn off after confirming the hot water is running
out.
RS68B
RS10B/RS10BV
Operating Instructions
To Next Page
Loading...
