EXERCISE
1. List the three major components that make up a basic 4020 system:
a.
b.
C.
2. Any I/O points defined as Notification Appliance (or Signal) Circuits, require
3. Power Supply Tap Enable Jumpers P3, P4, and P6 are installed on the
Board.
4. The setting of DIP Switch SW1 is dependent on the board’s
5. The only point in the 4020 system that can support a Coded Input Zone is I/O
6. Three components of the 4020 DO NOT have address DIP switches. List these components and give the
address of each one:
a.
b.
C.
7. Unlike the 4100, the 4020 Power Supply/Charger outputs the necessary charging voltage to the batteries at
what time?
8. The Port A Jumpers (Pl and P4 through P7) on the optional RS-232 Board are always in the
position.
9. DIP Switch SW2 on the Standard Slave Board is used to set the
Configuration.
10. The 4020 is programmed with Version
of the 4100 Programmer.
5
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...
