Coronet / 2400 / RE 200 Series
3
Quick Setup List
Setup Procedure Steps to Perform
Uncrating ❏ Remove crate & cut banding.
❏ Place transmission release lever in PUSH position & roll
tractor forward off skid.
Battery Activation & ❏ Charge the battery
(Note: proceed with other setup
Installation
steps while battery is charging).
❏ Test battery with hydrometer or load-tester.
❏ Install & secure battery.
❏ hydrometer or load-tester.
Assemble Rider (CE Only) ❏ Install Seat and Steering Wheel.
Check Fluid Levels ❏ Fill & check engine oil level.
❏ Reduce & check tire pressures
(Front tires 10-12 psi, Rear tires 10-12 psi).
Mower Assembly ❏ Level mower deck (Side-to-side & Front-to-back).
❏ Torque mower blades.
Lubrication ❏ Lubricate all grease & oil points.
Mower Assembly ❏ Level mower deck (Side-to-side & Front-to-back).
❏ Torque mower blades.
SAFETY CHECKS ❏ Check for LOOSE HARDWARE.
❏ Check all OPERATOR CONTROLS
.
❏ Test RETURN-TO NEUTRAL
.
❏ Perform MOWER BLADE STOPPING CHECK
.
(Blade must stop within 5 seconds!)
❏ Perform SAFETY INTERLOCK SYSTEM CHECK.
❏ Check the SEAT SAFETY SWITCH
and Terminal.
Burnish Electric Clutch ❏ Burnish electric clutch
(run for 15 seconds and stop, repeat
10 times)
.
❏ Repeat MOWER BLADE STOPPING CHECK
.
(Blade must stop within 5 seconds!)
Reverse Mow Option (RMO)
Adjustment ❏ RMO Adjustment.
Purge Air From Hydro ❏ Purge Hydro.
To Next Page
Loading...
