11
STEP 13a
Fitting of Bar End Plates
Secure the bar end plate into the end of the glazing bar using a No. 10 x 25 hexagon headed screw
(supplied). Please see the image below.
STEP 13b
Fixing the Gutter Trim
There are 3 trims the same length as the gutter, if the gutter is over 6m and has a join then stagger
the trim so that the join is in a different place. The trim fits into the channel on the front and the back
of the gutter, 1 trim on the front and 2 trims on the back (inside of the gutter). Simply hold the trim
close to the channel and using a rubber or fibre mallet tap the trim into place ensuring the bottom 2
trims have the flat section facing down. The top trim on the inside is fitted with the flat section of the
trim facing upwards.
To Next Page
Loading...