Simplicity Baron System 7013S - Lubricate Grease Fittings

Figure 22, Air cleaner with cover removed on left side of
engine.
squeeze It to distribute the oil even]?.
4. Install the foam precleaner as shown in figures 22 and 23+
5. See figure 21+ Replace the air cleaner cover (C) and fas¬
ten it securely with wing nut (B}-
LUBRICATE GREASE FITTINGS: Your tractor
has 7 grease fittings which should be lubricated every 25
hours with multi-purpose lithium base gun grease. Wipe the
fitdngclean and lubricate each one with five shots of grease,
or until the grease is seen being forced from the bearing.
When operating under extremely wet or dusty conditions,
lubricate more often. The grease fittings are located as fol¬
lows:
LOCATION ILLUSTRATION
Left Spindle Figure 21, [tent D
Right Spindle Figure 24, Item A
Clutch-brake Pedal Figure 24, Item 8
Steering Bracket Figure 25, Item A
Right Axle Hub Figure 25, Item A
Right Axle Figure 27, Item A
Figure 23- Air cleaner assembly disassembled.
figure 24- Right front corner of tractor.
LUBRICATE PIVOT POINTS: Every 25 hours a
film of grease should be placed at the end Of the neutral start
safety switch, on the steering gear and on the shuttle drive
brake detent to provide smoother operation and help re¬
duce wear. They are located as follows:
LOCATION ILLUSTRATION
Neutral Safety Start Switch Figure 15, Item C
Steering Gear Figure 25, Item B
Shuttle Drive Brake Detent Figure 9, Items C & D
A few drops of engine oil placed on the tractor pivot points
will help reduce wear and provide smoother operation of the
tractor audits controls. Every 25 hours or more often under
wet or dusty operating conditions, place a few drops of SAE
30 engine oil on the pivot points, being careful not to get
oil on belts or pulleys as it may cause them to slip. Pivot
points are located as follows:
Figure 25. Steering gear as seen from beneath tractor.
16