Simplicity Baron System 7013S - Check Tire Pressure; Check Transmission Oil Level

Figure 26- Grease zerk located inside right wheel hub.
LOCATION
Left Tie Rod End
Right Tie Rod End
Front Axis Pivot
Power Take Off Pivot
ILLUSTRATION
Figure 21, Item E
Figure 24, Item C
Figure 28, Item A
Figure 23, Item A
CHECK TIRE PRESSURE: Tires will last longer and
perform better if they are kept properly inflated. They
should be inflated as follows. Front tires 12 to 15FS1. Bear
tires 6-3 FSL
CHECK TRANSMISSION OIL LEVEL: See figure
30. Remove pipe phig (A) to check the oil level In line axle
housing. Oil should be level with the bottom of the threads.
If it is not, add SAE 90 weight transmission oiL Replace
the plug and tighten it securely.
1
-®
_ _iffi
i 1
1
1
J TJ
Figure 2S. Front of tractor showing axle pivot.
If it should be necessary to drain the axle housing, the drain
plug is located at (B). Always tighten it securely when replac¬
ing to prevent oil leakage.
CHECK BEVEL GEAR BOX OIL LEVEL: 5ee
figure 31. The bevel gear box fill plug is located at (A).
The gear box is properly filled when SAE 90 weight trans¬
mission oil is added until it touches the eud of the fill plug
dipstick assembly. Do not screw plug into housing when
measuring for oil level. Drain bevel gear housing by remov¬
ing drain plug (B). To prevent oil leakage, securely tighten
both fill and drain plugs. The fill phig assembly is vented.
Figure 29. Power take off idler pulley, pivot points as seen
from beneath tractor.
17