Simplicity Baron System 7013S - Replace Fuel Filter

CHECK BATTERY WATER LEVEL: See figure
32. Every 25 la ours, or mure often when operating the tree-
tor in temperatures above 72°Fj remove the 6 battery caps
(A) and check the water level in each cell. When the battery
is in use, water evaporates from it. Never allow the water
level in the battery to get below the top of the plates. Fill
the battery to the marking ring with distilled water as shown
in figure 32. If distilled water is not available, clean tap
water may be used.
EVERY 100 HOURS OR ONCE A YEAR
CLEAN OR REPLACE AIR FILTER ELEMENT:
The engine air cleaner is made up of two types of filters. The
foam filter {Figure 22, Item E) and a dry filtering element
The foam element should be cleaned and oiled every 25
hours as explained under the Every-25 Hour Maintenance
Services. Once a year or every 100 hours, whichever occurs
first, the paper element should be removed and cleaned or
replaced. Proceed as follows:
1. See figure 21.. Remove wing nut (B) and cover (C) from
the air cleaner.
2. See figures 22 & 23. Remove the foam element (B) and
clean and oil it as described in the Every 25 Hour Mainten¬
ance Service.
5. R emove wing nut (C) and remove the paper element from
the air cleaner.
4 Clean the element by tapping it gently on a flat surface.
If it is very dirty, replace the element or wash it in detergent,
and water rinse until water remains dear. The element must
be dried thoroughly before using.
5. See figures 22 fit £3. Replace the paper element and wing
nut (C) and tighten it securely.
6. Install the foam dement (B) over The paper element as
shown in figure 22.
7. See figure 21. Replace cover (C) and wing nut (B) and
tighten securely.
REPLACE FUEL FILTER: See figure 21.' Every 100
hours or more often under dirty field condition^ the find
filter (F) should be replaced CAUTION: DO NOT REMOVE
the fuel filter when the engine is hot, as
SPELLED GASOLINE MAY IGNITE. USE CARE WHEN
REMOVING AND INSTALLING CLAMPS iQh NOT TO
SPREAD THEM ANY MORE THAN NECESSARY AS
THEY MAY TAKE A SET AND NOT HOLD THE HOSE
TO THE FILTER PROPERLY.
In extremely dirty fuel conditions, the fuel filter may be¬
come filled with dirt and restrict fuel flow- Tbs filter can be
washed in solvent and blown out with compressed air and
used
REPACK FRONT.WHEEL BEARINGS: Every
100 hours of operation or once a year, the front wheal bear¬
ings should be removed and repacked with grease. Proceed
as follows:
ia