Simplicity Baron System 7013S - Operation

OPERATION_
Figure 1. Tractor instrument panel as seen from the operators position on tractor seat.
INSTRUMENTS AND CONTROLS-HOW TO
key as soon as the engine start?. Return the key to the vet-
UNDERSTAND AND USE THEM deal position to stop the engine. CAUTION: ALWAYS RE¬
MOVE THE IGNITION KEY WHEN CLEANING, ADJUST-
picture yourself seated on your tractor. Before starting the 1NG, OR SERVICING THE TRACTOR OR ANY ATTACK*
engine, lets learn how to understand and use the insttu- MENT OR WHEN LEAVING THE VEHICLE UNAT-
ments and controls. The paragraphs referring to the instru- TENDED,
meets and controls are illustrated in figures 1 through 4.
CHOKE CONTROL KNOB: (Figure 1. item E) The
choke control knob may be pulled out to increase the a-
IGNITION SWITCH: (Figure l T item F) To actuate the mount of fuel an taxing the engine for starting and cold wea-
ignitioD switch first insert the ignition key as shown. When ther warmup. When starting a cold engine in cold weather
the key is turned clockwise to the first position, the ignition puHtheohoke all the way out. Some choke may be required
is ON. In the ON position the lights, hourmeter, etc. will op- to start the engine when the air temperature is above 70 de-
eratt Turn the key clockwise past the ON position to the grees F or while the engine is stOl warm from being recently
START position to actuate the starter. THE TRANSMIT- run. After the engine has started, push the choke in slowly.
SION SHIFT LEVER MUST BE IN THE NEUTRAL POSI- In cold weather it inay be irecessaiiy to leare the choke pulled
TION AND THE POWER TAKE OFF CLUTCH CONTROL out slightly for three or four minutes while the engine warms
LEVER (S) MUST BE IN THE DISENGAGED POSITION up. NEVER OPERATE THE ENGINE WITH THE CHOKE
BEFORE THE STARTER WILL ACTUATE. Release the OUT AFTER IT HAS HAD SUFFICIENT TIME TO
2