Prestige, Conquest, & Broadmoor Series
1/2003 3
TP 300-2534-02-PR-SMA
Quick Setup List -
Page Setup Procedure Steps to Perform
4 Uncrating ❏ Remove Crate & Banding.
❏ Place Transmission Release Lever in PUSH position & Roll
Tractor forward off skid.
(Note: You may want to assemble
the steering wheel at this time.)
4 Battery Activation & ❏ Charge the Battery
(Note: proceed with other setup steps
Installation
while battery is charging).
❏ Test Battery with hydrometer or load-tester.
❏ Install & secure Battery.
5 Tractor Assembly ❏ Assemble the Steering Wheel
(Note that the thick spoke
faces the seat.)
❏ Assemble the Seat.
❏ Check the Seat Switch connection.
5 Check Fluid Levels ❏ Fill & check Engine oil level.
❏ Check Transmission fluid level.
❏ Reduce & check Tire Pressures
(Front tires 15 psi, Rear tires 6-8 psi).
7 Mower Assembly ❏ Install deflector.
❏ Torque mower blades.
❏ Attach mower Hitch & Leveling Rod.
❏ Set Gauge Wheels.
❏ Install Mower Deck onto Tractor and Attach Belt.
❏ Level Mower Deck (Side-to-side & Front-to-back).
11 Lubrication ❏ Lubricate all grease & oil points.
12 SAFETY CHECKS ❏ Check for LOOSE HARDWARE.
❏ Check all OPERA
TOR CONTROLS.
❏ Check D
ASH SAFETY LIGHTS.
❏ Test PARKING BRAKE.
❏ Perform MO
WER BLADE STOPPING CHECK.
(Blade must stop within 5 seconds!)
❏ Perform SAFETY INTERLOCK SYSTEM CHECK.
13 Burnish Electric Clutch ❏ Burnish Electric Clutch
(run for 15 seconds, repeat 10
times)
.
❏ Repeat MO
WER BLADE STOPPING CHECK.
(Blade must stop within 5 seconds!)
To Next Page
Loading...
