14
Regular
Maintenance
MAINTENANCE SCHEDULE & PROCEDURES
The following schedule should be followed for normal care of your rider and mower.You will need to keep a record of
your operating time.
See Before Before Every Every Every Spring
SAFETY ITEMS Page First Use Each Use 5 Hours 25 Hours 100 Hours & Fall
Check Safety Interlock System 7 ●●
Check Rider Brakes 23 ●●
Check Mower Blade Stopping Time 25 ●●
See Before Before Every Every Every Spring
NORMAL CARE ITEMS Page First Use Each Use 5 Hours 25 Hours 100 Hours & Fall
Check Rider/Mower for loose hardware — ●●
Check Engine Oil Level 15* ●●● ●
Check Engine Air Filter 15* ● ***●
Change Engine Oil & Filter ** 15* ***● Every 50 Hours ***●
Check/Adjust PTO Clutch 25 ****●
Lubricate Rider & Mower 16 ***●
Check Tire Pressure 14 ● ***●
Check Hydraulic Fluid 15 ● ***●
Check Fuel Filter 15 ●
Clean Battery & Cables 17 ●
Clean & Sharpen Mower Blades 18 ●
Inspect Spark Plug 15* ●
Tire Pressure
Front 25 psi (1,72 Bar)
Rear 15 psi (1,03 Bar)
Figure 10. Checking Tire Pressure
CHECK TIRE PRESSURES
Tire pressure should be checked periodically, and main-
tained at the levels shown in the chart. Note that these
pressures may differ slightly from the “Max Inflation”
stamped on the side-wall of the tires. The pressures
shown provide proper traction, improve cut quality, and
extend tire life.
* See the engine manufacturer's owner's manual.
** Change original engine oil after first 5 hours of operation.
*** More often in hot (over 85° F: 30° C) weather or dusty operating conditions.
**** Service after the first 25 hours, then after every 100 hours.
To Next Page
Loading...
