2
About this Manual
To the best of our knowledge and at the time written, the information con-
tained in this document is technically correct and the procedures accurate
and adequate to operate this instrument in compliance with its original ad-
vertised specifications.
Notes and Safety
Information
This Operator’s Manual contains warning symbols which alert the user to
check for hazardous conditions. These appear throughout this manual where
applicable, and are defined below. To ensure the safety of operating perfor-
mance of this instrument, these instructions must be adhered to.
Warning, refer to accompanying documents.
Caution, risk of electric shock.
This instrument is designed to prevent accidental shock to the operator when
properly used. However, no engineering design can render safe an instru-
ment which is used carelessly. Therefore, this manual must be read carefully
and completely before making any measurements. Failure to follow direc-
tions can result in a serious or fatal accident.
Technical Assistance
SIMPSON ELECTRIC COMPANY offers assistance Monday through Friday
8:00 am to 4:30 pm Central Time. To receive assistance contact Technical
Support or Customer Service at (715) 588-3311.
Internet: http://www.simpsonelectric.com
Warranty
and
Returns
SIMPSON ELECTRIC COMPANY warrants each instrument and other ar-
ticles manufactured by it to be free from defects in material and workmanship
under normal use and service, its obligation under this warranty being limited
to making good at its factory or other article of equipment which shall within
one (1) year after delivery of such instrument or other article of equipment to
the original purchaser be returned intact to it, or to one of its authorized
service centers, with transportation charges prepaid, and which its examina-
tion shall disclose to its satisfaction to have been thus defective; this warranty
being expressly in lieu of all other warranties expressed or implied and of all
other obligations or liabilities on its part, and SIMPSON ELECTRIC COM-
PANY neither assumes nor authorizes any other persons to assume for it any
other liability in connection with the sales of its products.
This warranty shall not apply to any instrument or other article of equipment
which shall have been repaired or altered outside the SIMPSON ELECTRIC
COMPANY factory or authorized service centers, nor which has been subject
to misuse, negligence or accident, incorrect wiring by others, or installation
or use not in accord with instructions furnished by the manufacturer.
S
HO
CK
HAZARD: As defined in American National Standard, C39.5, Safety
Requirements
for
Electrical & Electronic Measuring &
Controlling
Instrumen-
tation, a shock hazard shall be considered to exist at any part involving a
To Next Page
Loading...
Need help?
General
