10
2. INSTALLATION
This section contains information and instructions for the packaging and ship-
ping of the 886-2. Included are procedures for unpacking and inspection, ser-
vice, shipping, battery installation, installation and care.
2.1 Unpacking And Inspection
Examine the shipping carton for obvious sign of damage. If shipping carton is in
good condition, inspect the Instrument for possible damage incurred during ship-
ment. If damaged, notify the carrier and supplier and do not attempt further use of
the Instrument. If the Instrument appears to be in good condition, read Operator’s
Manual in its entirety. Become familiar with the Instrument as instructed in the
manual, then proceed to check the electrical performance as soon as possible.
2.2 Shipping
Pack the Instrument carefully and ship it prepaid to the proper destination. Insure
the Instrument. Save the shipping carton and packing materials for future storing
or shipping of the Instrument.
2.3 Service
This Instrument contains no operator serviceable parts, except for the battery.
Refer all service requests to the Simpson factory. If the Instrument is covered by
warranty, include the model number, serial number, and date of purchase.
2.4 Battery Installation Or Replacement
The 886-2 is powered by a 9-volt alkaline battery. The battery is packaged sepa-
rately. To install or replace the battery:
a. Turn the range switch to the “OFF” position.
b. Using the screwdriver or coin, loosen the two screws located on the battery
cover access compartment and remove the cover.
c. Install or replace the battery with the connector on the left side of the Instru-
ment. Route the cable between the battery and upper wall of the battery
compartment.
2.5 Installation
The Instrument, when in operation, may be either hand-held or mounted on a
tripod. The physical position of the Instrument does not affect the accuracy.
2.5.1 Tripod or Strap Mounting
The 886-2 can be attached to any commercial, photography-type tripod having a
standard 1/4-20" mounting screw. The mounting screw is aligned with the threaded
insert in the case and finger-tightened. A camera-type carrying strap can be
attached to the threaded insert. Carry the Instrument with the strap around the
wrist to prevent accidental dropping.
2.5.2 Remote Microphone Mounting
A remote cable and microphone adapter can be used to mount the microphone to
To Next Page
Loading...
