9 - ENG
4
Connect Spray
Wand to Spray
Gun
Thread the spray wand into
the end of the spray gun.
5
Connect QC
Nozzles to Spray
Wand
Pull quick connect cou-
pler back and insert
nozzle. Release quick
connect coupler and
twist nozzle to make sure
it is secure in coupler.
6
Turn Water
Faucet
Completely On
Do not run the unit
without water supply
connected and turned on.
Use Cold Water Only.
7
Release Air from
System
Release all air from
pump and high pressure
hose by depressing
trigger until a steady
stream of water is present.
Approximately 30 seconds.
30 S
8
Verify the Engine
Switch is turned
to the ON
Position
See Label #8 on the
side of the engine.
OFF
ON
9
Verify the Choke
Pin is Pulled Out
to the CLOSED
Position
The Choke Pin has been
preset by the factory to be
in the CLOSED Position.
See Label #9 on the
side of the engine.
10
Pull the Recoil
Starter Grip
Pull the
recoil starter grip to
start the engine.
See Label #10 on the
side of the engine.
11
Push the Choke
Pin to the OPEN
Position
Gradually move the Choke
Pin to the OPEN Position
after engine starts.
See Label #11 on the
side of the engine.
WARNING: This Guide is not a substitute for reading the operator's manual. User must
read and understand operator's manual before using this product.
Please contact us for further information at www.allpartsinc.com
To Next Page
Loading...
