SimPure DB10 - Introduction

Troubleshooting Guide
Tap water pressure is too high; make sure it is below
90psi (620kpa). If too high, fit a pressure regulator.
Leaks between [ppq 0-ring may not be in place. Clean and lubricate O-
filterhead and | yjng with silicone grease. Also, clean the groove
fllter'bowl of where the O-ring sits. Replace O-ring in the groove
housing above threads. Screw the bowl back on the filter head
securely by hand, then use the wrench to fit it snugly.
Do not over tighten
Wrap the Teflon tape around pipe threads of each
Leaks on fitting in a clockwise direction, add more tap as
inlet/outlet necessary for the correct seal.
connections Brass fittings may require to tighten %-turn with a
wrench. Do not over tighten
The pressure release button has a screw under the
Leaks from the bracket.Simply tighten that screw and the leaking
pressure
release button | should stop.
Water Pressure | Recommended changing the cartridges every 6-12
is slowing after | months depending on the amount of contaminants
some time present in the feedwater supply. If the system has
been working correctly and the water pressure is
slowing, it may be time to change the filter cartridge
element. (review cartridge instructions)
Check the filter cartridge has not been installed
Water Pressure | incorrectly. Make sure the plastic wrapper around the
is slowing filter has been removed.
immediately Bathtubs, utility sinks, garden hoses, showers, or
after anything considered high-flow should be avoided for
installation the first 72 hours. Any high-flow situation within the
when using a first 72 hours may cause a temporary carbon
Carbon blockage. To clear the blockage, turn off any running
Cartridge water for atleast 10 minutes and resume using water
atlow or regular flow rates.
Water appears | Water may appear cloudy or grey for the first 3-5
cloudy and grey | days after installation due to the tiny air bubbles
being purged from the filters and extra carbon dust in
the water. (depended on the filter cartridge being
used)
13
Getting Started
Introduction
Thank you for purchasing the SimPure® Whole House Water Filter. There
are four models: DB10, DB20, DB10-PP, and DB10-CTO, which incorporating
arugged solid design, helping to deliver filtered water to your home or office.
Please refer to the SimPure® website for the latest product information,
including manuals, product videos, support materials, and where to
purchase SimPure products and consumables.
The water filter housing is a durable piece of
equipment; it will last for many years with
proper care. This owner's handbook outlines the
installation, operation, and maintenance
requirements to sustain perfect product
performance.
Customer Service: service@simpurelife.com
Phone: +1-866-528-4572
Website: www.simpurelife.com
The water filter housing, when fitted with a SimPure filter cartridge, will
guard your property against poor incoming water quality. Removing impurities
and particulates from your water, such as sediment, dirt, and rust. Designed to
be your first line of defense, protecting your water appliances such as washing
machines, dishwashers, water heaters, and pretreatment for house filtrations
systems, improving the water quality, and protecting kitchen and bathroom
faucets and showers fittings from blockage.