SimPure Q3-600 - Warning and Safety Information; General Safety Precautions

Warning & Caution
SimPure® products are designed with safety in mind. However,personnel
working on these units must be familiar with any potential dangers. All
safety information detailed in this handbook should be reviewed before
installing and operating this water purification system.
Thoroughly flushing of the unit is required at start-up and when filters
replaced (flushing instructions on page 15 of manual). The purpose
of flushing is to remove protective liquid (Food-Grade Glycerin) in RO
membrane and possible shipping dust.
This product is not a toy, please keep children away from the
System or use under adult supervision. Please keep packing
materials out of children's reach.
The System has been designed for indoor use only. Install the System
out of direct sunlight and secure it to a vertical surface such as a wall
or inside a cupboard at ambient room temperature.
Do not move the System without first shutting off the water supply,
draining, and releasing the water pressure.
This unit is for use with cold municipal tap water or potable well
water that has been tested safe by a certified laboratory. Never use
hot water or unknown/unsafe sources of water.
The installation of the System must comply with your local and
state regulations. Please check before commencing installation.
In case of malfunction, shut-off the water supply to the System.
Ifany part of the System is damaged or missing, replace the item
before use.
Warnings and Cautions are provided; Failing to observe the instructions
could result in damage to the equipment, associated parts, surroundings,
or personal injury.
Operating Guidelines
The following table lists the operating parameters for this product. Operating
this product outside these specifications may cause system performance issues
and may even lead to personal injury and void any warranty. Please contact
SimPure® for further advice and support if you are uncertain about the
requirements.
e ng Parameters
Model SimPure® Q3-600
600 Gallons per day
Maximum Flow Rate Note: Dependent on feedwater type, operating
pressure and water temperature.
Power Requirements 110Volts 60Hz AC. 85w
Municipal Potable/Tap water or Well water
Feed Water Type meeting government drinking water
standards.
15-60 PSI
Feed Water Pressure Note: Install a pressure regulator if
exceeding this feed water pressure.
Feed Water Temperature | 41-100°F (5-38°C)
Ambient Temperature 40-104°F (4-40°C)
Feedwater TDS* level <500 ppm
Water Hardness For optimal results, use feed_water with a
(Optional) hardne§s level below 10 grains per gallon
and no iron present.
*TDS = Total Dissolved Solids, which i thetotal weight of al solids dissolved ina given volume of water,expressed i units of mg per
unit volume of water (/L) also referred to as parts-per-million (pprm). With a SimPure® TDS meter, you can easily compare the
system outlet quality with your source water to help monitor the performance of the system