SimPure V7 - Page 12

Installation Steps
Step 1 - Installing the V7 Assembly
—
Outlet hose Inlet hose
Step 2 - Plumbing Instructions
Connecting Tubing.
Using the inlet hose and outlet hose
connect up the V7 taking notice of the
direction of water flow, IN to OUT is
marked on the V7 filter base.
Locate Shut off valve. Turn off the
COLD water shut off valve located
under the sink.
Warning: Make sure you have turned
the water supply off before starting
any plumbing work.
Remove the original connection
from between the faucet and the cold
water shut off valve under the sink.
Step 3 - Connections
Follow the instruction below to connect the SimPure® V7 Filtration System.
1. Connect the water supply (cold water only).
Connect the inlet hose to the cold water valve.
2. Connect to the faucet.
Connect the outlet hose to the faucet hose.
Step 4 - System Flushing
After assembling the SimPure® V7, turn on the faucet to flush the System for
5 minutes to rinse all fittings and the new filter. Check for any signs of leaks.
10