SimPure V7 - Installation Kit

Installation Kit
Carefully unpack your SimPure® V7 Water Filtration System. Layout the parts
so you can familiarize yourself with the components, check nothing is missing
before you start the installation.
Package Contents List
Main body (including the cartridge)
3/8” Braided stainless inlet hoses (29.5 inches)
3/8” Braided stainless outlet hoses (29.5 inches)
Spare wrench tools
Spare parts kit
Teflon tape (roll)
Elbow %" tube QC to threaded (x2)
3" male comp. x %" female NPT convertor fitting
1" male NPT x ¥" female comp. convertor fitting
Installation Guide
Read the entire manual thoroughly before beginning your installation. Take
note of the safety tips and follow all steps to ensure your System is installed
correctly before use. Installation needs to comply with state and local laws and
regulations; you must check and comply with all local plumbing codes. Warning:
Massachusetts, USA, require installation by a licensed plumber and does not
permit the use of saddle valves. (plumbing code 248-CMR of the Commonwealth
of Massachusetts)
Hand tools required
Essential hand tools are required to install the SimPure® V7 System.
Adjustable wrench, cross-head screwdriver (Phillips).
9
Plan your Installation
Your SimPure® V7 System can be installed under a sink or in a remote location.
Typical remote sites are a laundry room or utility room.
Dispense Point
The V7 is an inline Purification System designed to be installed into an existing
cold water dispense point, such as a faucet. Should you require a separate outlet
for the V7, please purchase a drinking faucet or other style outlet suitable for
your application and follow the manufactures installation instructions.
Check Location and Space Requirements
Determine and check the size and position of the V7 for proper installation into
the chosen space and remember to leave enough room around the System for
changing filters and maintenance.