SimPure Y7P-W - Page 13

Flushing Indicator Light & Button
Push 1s
\
Emptying function
hold 5s
V
Manual
membrane flushing
13
Power on - The System will automatically flush the
membrane for the first 30 seconds. While flushing,
the indicator light will be on.
Emptying function - Push the Flushing button, the Flushing
button will flash; purified water will start to flow from the
outlet until the internal Tank empties. To manually stop
dispensing water, push the button a second time, the blue
light goes off.time. While flushing, the indicator light will
be on.
Manual membrane flushing - Push and hold the Flushing
button for 5-seconds, you will hear 1-beep, the Flushing
button will be on, and the System will flush the membrane
for 60 seconds and stop. To cancel the manual flush, push
the button a second time. To manually stop dispensing
water, push any other button, the blue light goes off.
Complete filtering - The System will automatically flush
the membrane for 18 seconds after complete filtering.
While flushing, the indicator light will be on.
Note: Membrane flushing is internal flushing, the water
after flushing will return to the feed water tank for
circulation, and this will not affect the quality of purified
water after filtering. Also, no water will flow out of the
water outlet during this process.
UV Indicator Light
Steady- While purifying water, the UV light
will operate, staying on a further 1-hour after
the pure water tank is full.
Startup- When the System is reconnected to
the power outlet, the UV will function for the
first 3-hours and then shut off automatically.
Filtering- When the system is filtering the water,
the UV light will always operate to help maintain
microbial control of the purified water.
Standby- The UV light will operate for 15
minutes every 20 minutes to help maintain
microbial control of the purified water.
Change Water Indicator Light
k=l
Flashing- Feed tank water lower than the Min.
Level. You will hear 10-beeps, and the System
starts up, releasing pressure for 10 seconds.
Once complete, remove the Feed Tank, empty
ALL the remaining concentrate water, and
refill with fresh potable (tap) water (do not
reuse the remaining water as it will be high in
salts). Refit the Feed Water Tank to the System.
Steady- Feed Tank has been removed from the
base. Light will go out when the Tank is
returned into the System.
IMPORTANT- If you do not remove and empty the Feed Water Tank
and instead add water directly to the Tank, the Change Water
indicator light cannotbe cleared. Lift the Feed Water Tank out of the
System, empty the concentrate and refill with fresh potable (tap)
water, then replace the Tank into the System to clear the Change
Water indicator light.
Pure Water Shortage Indicator Light
internal
pure water
reservoir
Flashing - Indicates that there is not enough
pure water in the internal pure water reservoir,
the System automatically starts filtering water
refilling the internal reservoir. NO water can be
dispensed while the light is flashing. Please kindly
wait for about 10 mins until the "filtering" light
is off.
Off - When filtered water is available in the internal
reservoir, the "Pure Water Shortage" indicator light
goes out, and when the "filtering" light is off, you
can dispense water again.
14