No. Description
1 CMD/Thruster. Press once to take/request command. Press and hold to activate/
deactivate available thrusters
2 MENU. Press once to display the active steering mode’s quick menu. Press twice to
display the Settings menu
3 PWR/Light. Press to display the Light dialog. Press and hold to turn the unit ON/
OFF
4 Course knob. In menus; turn to select menu item and adjust value, press to
confirm. In FU mode; turn to set rudder angle. In STBY and NFU mode; press to go
to FU mode. In AUTO and NoDrift mode; turn to change set heading/set course,
press to capture present heading. In NAV/TRACK mode, turn to set track offset
5 PORT. In menus; press to return to previous menu level. In STBY and FU modes;
press to go to NFU mode. In AUTO and NoDrift modes; press to change set
heading/set course to port
6 STBD. In menus; press to confirm menu selection/enter next menu level. In STBY
and FU modes; press to go to NFU steering. In AUT O and NoDrift modes; press to
change set heading/set course to starboard
7 TURN. Press to display the Turn dialog
8 STBY. Press to switch the autopilot to Standby mode
9 AUTO. Press to activate Auto or NoDrift mode
10 NAV/TRACK. Press to activate NAV/TRACK (AP80) steering modes
11 WORK. Press to display the Work profile dialog
12 ALARM. Press to display the Alarm dialog (AP80 only)
13 USB connector (AP80 only)
EN
To Next Page
Need help?
General
