What to do if Simrad AP21 autopilot operates on simulated feedback?
If your Simrad Marine Equipment autopilot operates on simulated feedback due to rudder feedback failure, it means the rudder feedback signal is either missing or erratic. First, check all connections. Then, check the alignment according to the installation instructions. If the problem persists, replace the rudder feedback unit.
How to fix a slow rudder test on Simrad AP21?
If the rudder test is too slow on your Simrad Marine Equipment, it could be due to excessive load on the steering gear, air in the hydraulic system, or insufficient drive unit capacity. You should: 1. Look for mechanical obstructions at the rudder/tiller/quadrant and check the back drive force. 2. Bleed the hydraulic system. 3. Replace the existing unit with a bigger pump unit.
Explanation of FU and NFU steering modes.
How to engage and use the automatic steering mode.
Using the autopilot for navigation with external sources.
Guide to configuring user settings and parameters.
Detailed installation for feedback, junction, control units, and sensors.
Instructions for installing various drive units.
Guide to system configuration via software menus.
Configuration steps performed before sea trials.
Procedures for testing and calibrating the system at sea.
Diagnosing and resolving system alarms.
General| Brand | Simrad |
|---|---|
| Model | AP21 |
| Category | Marine Equipment |
| Language | English |
To Next Page
