Operation
20220596G 17
Software V(ersion) and R(elease)
Junction unit model
P00 M00 S000
SW V1R8
J300X
Robertson
Self check
Power board revision
Main board revision
Software V(ersion) and R(elease)
Autopilot model
HW rev. 0
SW V1R3
AP22
Robertson
Hardware revision
SW and HW revisions shown are examples only.
After approx. 5 seconds the system is operative and the unit that
was turned on will show the STBY mode display. Other units in
a multistation system will display "Inactive". Control can be
available at any unit by pressing the STBY button.
First press
Standby mode
Current heading
STBY
STBY
Second press
RFC
P
S
12
Standby mode.
Current heading from RFC compass.
HI speed parameter manually selected.
Rudder angle: 12 degrees to starboard.
A long press (2-3 sec.) on the STBY button switches the system
OFF.
Note ! In an emergency it is possible on a multistation system to turn
OFF the system at any control unit by pressing down the STBY
button for 2-3 seconds.
STBY mode is also the mode that is used when steering the boat
at the helm.
To Next Page
Loading...
Need help?
General
