Operation
20220596G 25
Origin
Waypoint 2
New heading accepted
automatically after
NAV/SETUP button is pressed
Waypoint arrival zone
(determined by the navigator)
Waypoint 1
2.12 Selecting a different Navigator
If you have more than one navigation source connected to the
autopilot, you will be able to choose any for navigation. Refer to
the User Set-up menu for details on selecting a different
navigator.
Note ! If the autopilot is connected to a navigation receiver that does
not transmit a message with bearing to next waypoint, it will pick
a XTE message and steer on Cross Track Error only. In that case
you have to revert to AUTO mode at each waypoint and
manually change set course to equal bearing to next waypoint
and then select NAV mode again.
To Next Page
Loading...
Need help?
General
