Need help?Do you have a question about the Simrad AP70 MK2 and is the answer not in the manual?
General| Brand | Simrad |
|---|---|
| Model | AP70 MK2 |
| Category | Marine Equipment |
| Language | English |
Details the function of each key (A-L) on the autopilot control unit.
Describes the components and indicators of the heading repeater display.
Explains status icons, active mode, and abbreviations used.
Details content of the mode info panel and thruster information display.
Explains the rudder position indicator with digital and analog readouts.
Provides warnings and guidelines for safe autopilot use, including when not to use it.
Instructions for turning the system ON and switching to sleep mode.
Describes the three different quick menus (Mode, Work profile, Turn).
Explains its use for system setup and configuration.
Explains setup of different steering stations and network groups.
Describes default open system behavior and command transfer.
Explains the Master function for controlled command transfer in Wheelmarked systems.
Describes Standby, Non-Follow Up (NFU), and Follow-up (FU) modes.
Introduces Auto compass and NoDrift modes.
Requires connected navigator to steer to waypoints using heading and position.
Describes Normal, High, and Low profiles assigned based on vessel type.
Steps to define new profiles for specific operational modes.
Differentiates between Alarms (critical) and Warnings (potential issues).
Describes siren, alert icon activation, and pop-up display.
Procedures for acknowledging (ACK) or silencing alerts.
Describes system behavior during rudder or compass failures.
Instructions for cleaning the screen and housing using soft cloths and water.
Function to back up and restore user settings.
Instructions for updating software from a storage device via www.navico.com.
Describes Quick menus as mode-dependent, accessing common settings.
Lists Level 1 and Level 2 menu options for Auto mode.
General system configuration and installation setup described in a separate manual.
To Next Page
