Maintenance
20220596G 109
5 MAINTENANCE
5.1 Control unit
The AP21 and AP22 Control Units will under normal use require
little maintenance.
If the unit requires any form of cleaning, use fresh water and a
mild soap solution (not a detergent). It is important to avoid
using chemical cleaners and hydrocarbons such as diesel, petrol
etc.
Make sure that all open ROBNET connectors are fitted with a
protection cap.
It is advisable at the start of each season to check all connections
to the control unit head and cover with Vaseline or WD40. If the
Control unit is not removed from the boat, it should be covered
with the white protection cover.
5.2 Junction Unit
No special maintenance is required. It is advisable, however, at
the start of each season to make a visual inspection of the
internal and check all connections.
5.3 Rudder Feedback
Make a visual inspection at 2-3 month intervals and at the start of
each season. Apply some grease at the ball joints when required
(RF300)
5.4 Compass
If the compass is exposed to the weather, make a visual
inspection at 2-3 months intervals, and at the start of each season.
5.5 Drive unit
Refer to the drive unit manual for maintenance instructions.
To Next Page
Loading...
Need help?
General
