Simrad AP21 and AP22 Autopilots
94 20220596G
Rotate the course dial clockwise until the transition speed is set
to the desired value in knots.
Proceed to next menu item by pressing STBD [>] button.
Interface Settings
The autopilot system provides a totally flexible approach to the
input of data from heading sensors and other peripheral
equipment. Identification of the type of equipment connected to
the autopilot system is performed in the Interface Menu.
When your system includes connection of external equipment to
the NMEA0183 data ports in Junction Unit or NI300X, or if the
CI300X is installed with optional compass units or an optional
analogue wind vane unit, they must be configured under the
Interface Menu. This procedure allows you to assign an
abbreviated name to identify the type of equipment that is
connected to each of the available hardware ports in the autopilot
system.
To Next Page
Loading...
Need help?
General
