Direct step mount bracket and supplies (not included)
Maximum 5 mm (#10 or 3/16”)
self-tapping metal screws
To direct step mount using flush bracket
1. Make sure the boat’s step is the same length or longer than the
transducer.
2. After selecting a mounting location, route the transducer cable
to the location where the display will be installed.
3. Attach the transducer to the surface bracket and hold in the
desired position. Use a pencil to mark pilot holes through the
mounting holes on the surface bracket.
4. Drill the pilot holes.
5. Apply a marine high-grade above- or below-waterline sealant/
adhesive compound to the pilot holes.
6. Align the transducer mounting holes over the pilot holes and
mount the transducer to the step using self-tapping metal
screws (not supplied). Do NOT overtighten the screws;
otherwise you could strip out the fiberglass pilot holes or crack
the mounting holes on the transducer.
7. Connect the transducer cable to the display sonar port.
After the transducer is connected and your boat is in the water, turn
on the Flip Left/Right feature in your display unit to ensure what is
shown on the left and right side on your display corresponds with
what is on the left and right side of your boat. Refer to your display
unit's Operation manual for more information.
Jackplate mount (Transom bracket)
12
Installation | TotalScan Transducer User Manual
To Next Page
Loading...
