8. Slide M6 bolts with washers into each hole on the side of
jackplate.
9. Guide the bolts through the Transducer mounting bracket
holes.
10. Place a washer over the end of the bolts and tighten the nuts.
11. Connect the transducer cable to the display sonar port.
After the transducer is connected and your boat is in the water, turn
on the Flip Left/Right feature in your display unit to ensure what is
shown on the left and right side on your display corresponds with
what is on the left and right side of your boat. Refer to your display
unit's Operation manual for more information.
14
Installation | TotalScan Transducer User Manual
To Next Page
Loading...
