be in the water when you are on plane, or can be mounted so it is
only in the water when you are moving at trolling speed.
Transom and Step mount (fiberglass) supplies (not
included)
3 mm (1/8”) Drill bit (Transom
mount pilot holes)
Marine high-grade above- or
below-waterline sealant/
adhesive compound
Transom mount (aluminum hull) supplies (not included)
M4 Machine Screws Marine high-grade above- or
below-waterline sealant/
adhesive compound
Plastic isolating material such as King Starboard (prevents
corrosion between bracket and aluminum hull)
To mount on transom or step using the transom
bracket
1. Snap the plug to the bracket (A)
2. Attach the bracket and name tag insert to the transducer using
the supplied screws (B)
3. Loosely attach the bracket with the transducer to the transom
mounting plate using the supplied bracket assembly bolt,
washer (closest to the screw head), rubber spring washer and
nylon lock nut (C)
4. Hold the whole assembly up against the transom or transom
step to the desired position. If mounting on the transom, align
the bottom of the transducer with the bottom of boat. Use a
pencil to mark the pilot holes (D). The transom mounting plate
has screw slots for adjusting the transducer position height.
5. Drill the pilot holes
6. Apply a marine high-grade above- or below-waterline sealant/
adhesive compound to the pilot holes
7. Disconnect the transom mounting plate from the transducer
bracket
8. Screw the transom mounting plate to the transom using the
supplied screws and flat washers (E)
Installation | TotalScan Transducer User Manual
9
To Next Page
Loading...
