Simrad MX510 - Page 47

Keypad & Display Description | 45
To move a range of waypoints, enter the rst and last waypoint numbers to b
move on the First WPT Number and Last WPT Number. Keep in mind that the
CDU will sort these waypoints numerically and all waypoints between the
entered numbers will be moved to the new location.
Enter the waypoint number where you want the rst waypoint moved to in
6
Destination WPT Number.
If the destination waypoint number is already being used, you will be prompted
to either overwrite the first waypoint (Yes) and each subsequent waypoint that
is to be overwritten, confirming each waypoint one at a time, overwrite all the
waypoints (Yes To All), not overwrite any waypoints (No); or Escape back to base
softkey menu. Don’t forget to press the EDIT key to exit.
3. Make New WPT
4a. Use WGS-84 Datum.
Select Lat/Lon (W84)
4b. Use Datum other
than WGS-84.
Select Lat/Lon Datum
5. Enter Coordinates.
Press the cursor
down arrow.
7. Modify WPT Text
& Symbol (Optional).
Press the Done softkey.
6. Modify WPT Number
(Optional).
Press the cursor
down arrow.
Enter desired range
and bearing.
Press the cursor
down arrow.
4c. Create a new WPT based
on a Range & Bearing
from an existing WPT.
Select Range Bearing
Select desired datum
from displayed list.
Press Select.