Troubleshooting
LED indicators
5 LEDs on the unit's cover indicate status for the S5100, for the network and for connected
transducers.
POWER NETWORK CHANNEL-1 CHANNEL-2 CHANNEL-3
Power LED
• OFF
- No power connection
• Check power and power cable
• Check yellow wire
• ON - Red
- System starting
• ON - Green
- System operational
• FLASHING - Red/Green
- Software error or unit reprogrammed
• Restart the unit
• If still not ok, contact Customer Support
Network LED
• OFF
- No Ethernet connection
• Check cable
• ON - Green
- Ethernet connected and ok
Sonar LEDs
• OFF
- Transducer not connected
• FLASHING every 0.5 second - Red
- Initializing transmitter
• FLASHING every second - Green
- Searching for bottom signal
• ON - Green
- System operational
4
14
Troubleshooting | S5100 Installation Manual
To Next Page