DC Inverter Duct Type Air Conditioner Installation and Operation Manual
15
(continued)
Fig.14 Turbo Function Setting
Note:
TURBO function will be turned off after power failure and then recovery. In dry, fan and auto mode,
TURBO function can not be set and TURBO mark won’t be displayed.
TURBO function will be automatically canceled after setting of quiet function.
4.10 SAVE Function Setting
Energy Saving Function: Energy saving can make the air conditioner runs in a smaller temperature range
by setting lower limited value of setting temperature in cooling or dry mode and upper limited value in heating
mode.
①
Energy Saving Setting for Cooling
Under on-state and in cooling or dry mode of the unit, press Function button into energy saving function,
with SAVE blinking .Press ▲ or ▼ button to adjust lower limited value of setting temperature in cooing mode.
After that press Enter/Cancel button to turn on energy saving function for cooling.
Under on-state and in cooling or dry mode of the unit, press Function button into energy saving function ,
with SAVE blinking .Press ▲ or ▼ button to adjust lower limited value of setting temperature in cooing mode.
After that press Enter/Cancel button to turn on energy saving function for cooling.
②
Energy Saving Setting for Heating
Under on state and in heating mode of the unit, press Function button into energy saving function, with
SAVE blinking. Press Mode button into energy saving function for heating and then press▲ or ▼ button to
adjust upper limited value of setting temperature in heating mode. After that, press Enter/Cancel button to turn
on energy saving function for heating.
After energy saving function is turned on, press Function button into energy saving function and press
Enter/Cancel to cancel this function.
The energy saving setting is shown in the g15:
To Next Page
Loading...
