4
Remote signal receiving
function
The wired remote controller can be
a remote signal receiving device,
you can use the wireless remote
controller to control the air-conditioner
through the wired remote controller
when the system have been powered
on.
CAUTION
The wired remote controller will not
receive the swing controlling
instruction. For the indoor unit with
s
winging function, you can directly
use the wireless remote controller to
control swinging through the display
panel of the indoor unit or use the swing
button on the wired remote controller
to control the indoor unit for swinging.
On and Off the air-conditioner
Press the On/Off button to control
the indoor unit turn on and turn off status.
When the unit is turned off, press the
On/Off button, the unit will be turned
on and the operating icon
When the unit is turned on, press the
On/Off button, the unit will be turned off
and the operatin
g icon
li
ghts up
Set the operating mode
Press the mode button to set the
operating mode, after each button
press the operation mode will circle
as follow:
AUTO
→
COO
L
→
DRY
→
HEAT
Under COOL, HEAT and FAN modes,
→
AUTO
Under COOL, HEAT and FAN modes
When the controller has been set to
cool-only, then there is no HEAT mode.
Fan speed setting
Under Auto and Dry modes the fan speed
is not adjustable and the default fan
speed is AUTO.
Temperature setting
Under AUTO, COO
L, DRY, HEAT
setting buttons
to set the
temperature, the adjusting range is
17°C
- 30°C (or 62°F-88°F)
Press temperature setting button to adjust
the timer.
When the timer setting
than 10 hours, each press will increase or
decrease 0,5 hour.
is more than
10 hours, each press of temperature setting
buttons
When the timer setting is less
will increase or decrease 1 hour.
and
press the fan speed button can adjust
the fan speed setting.
After each fan speed button press
will circle as follow:
After finish adjusting the timer on setting,
press the
OPERATION
INSTRUCTIONS
lights off.
AUTO
→
LOW
MID
→ →
→
HIGH
→
AUTO
modes, press the temperature
and
The setting temperature cannot be adjusted
under FAN mode.
FAN
button or wait for 5
seconds to confirm and exit the timer on
setting.
Timer on and Timer off setting
Press the timer/clock setting button,
then enter into the timer on setting status
and the screen will display
.
The maximum timer setting is 24 hours.
To Next Page
Loading...
