Installation
Installation and
maintenance must be
carried out by suitably
qualified personnel.
The equipment must be
installed in accordance with
applicable state electrical
standards, decrees and
regulations.
Use a separate power
supply circuit and circuit
breaker with the required
parameters according to the
relevant safety regulations.
All wiring for indoor and
outdoor units must be
installed by a professional.
Disconnect the power
supply before starting any
work on the electrical
equipment.
Check that the power
supply meets the
requirements of the air
conditioner.
An unstable power supply
and/or improper connection
may cause electric shock,
fire and/or malfunction.
Install the appropriate
power cords before using
the air conditioner.
Ground resistance must
comply with applicable
electrical safety standards.
The air conditioner must be
properly grounded.
Improper grounding may
cause electric shock.
Do not connect the power
supply until installation is
complete.
Install a circuit breaker.
Otherwise, the equipment
may be damaged.
When permanently
connected to the power
supply, a switch that
disconnects all poles and
whose contacts are at least
3 mm apart in the off state
must be used to switch off
the unit.
The circuit breaker must
protect against short circuit
and overload.
To Next Page
Loading...
