The Auto Clean function can only operate at normal
ambient temperatures. If there is a lot of dust in the
room, perform cleaning once a month, otherwise
once every three months. You can leave the room
after the Auto Clean function is switched on. When
the automatic cleaning is finished, the air
conditioner will go into standby mode.
This function is only available on some models.
Night mode
When the Sleep mode is switched on in Cool or
Heat mode and the speed is set to low or silent,
the outdoor unit will go into night mode.
If you feel that the cooling or heating is not effective,
switch the fan speed with the Fan button or press
the Sleep button to exit the night mode.
Night mode can only operate at normal ambient
temperature.
This function is only available on some models.
I FEEL function
Press the Health and + buttons simultaneously to
activate the I FEEL function. Indicator will
appear on the remote control display. When this
function is switched on, the remote control will
send the temperature reading to the unit and the
unit will automatically regulate the room
temperature according to the temperature
measured by the remote control sensor. To
switch off the I FEEL function, press the Health
and + buttons again simultaneously. Indicator
disappears.
After switching on this function, place the
remote control near the user so that the indoor
unit can receive the signals sent by the remote
control. Do not place it near an object with a
high or low temperature, otherwise the ambient
temperature measurement will not be correct.
Replacing the batteries in the
remote control
1. Press the back of the remote control at the
point marked , as shown in the picture, and
then slide out the battery compartment cover in
the direction of the arrow.
2. Replace two 1.5V AAA batteries. Make sure
that the + and - orientation of the poles of the
batteries is correct.
3. Reinstall the battery cover.
During operation, point the remote control signal
transmitter at the receiver window on the air
conditioner.
The distance between the signal transmitter and the
receiver window should be no more than 8 m and
there should be no obstacles in the signal path.
In a room with fluorescent lighting and/or a cordless
telephone, interference with the signal may occur.
In this case, the remote control should be brought
closer to the indoor unit.
When replacing the batteries, use the same type of
batteries.
Remove the batteries from the remote control if you
are not going to use it for a long time.
Replace the batteries if the indicators on the remote
control display are hard to see or do not appear at
all.
To Next Page