4
Wired Controller SWC-04
3 Operation Instructions
Fig. 5 “ON” State
3.2 Mode Setting
3.1 ON/OFF
Press ON/OFF to turn on the unit and turn it off by another press.
Auto Cooling
Dry Fan
Fig. 4 “OFF” State
Heating
3.3 Temperature Setting
Press ▲or ▼ to increase/decrease the preset temperature. If press either of them continuously,
the temperature will be increased or decreased by 1°C(1°F) every 0.5s, as shown in Fig.6.
In the Cooling, Dry, Fan or Heating mode, the temperature setting range is 16°C~30°C(61°F~86°F).
In the Auto mode, the setting temperature is unadjustable.
Wi
Fi
Under the “ON” state of the unit, press MODE to switch the operation modes as the following
sequence:Auto-Cooling-Dry-Fan-Heating.
Note: The state shown in Fig.4 indicates the “OFF” state of the unit after power on. The state
shown in Fig.5 indicates the “ON” state of the unit after power on.
Wi
Fi
Note:
If the wired controller receives the signals of remote controller, the wired controller can analyze the set
temperature adjustment function of automatic mode of the remote controller, but it needs to be used
with an indoor unit with the set temperature adjustment function of automatic mode.
To Next Page
Loading...
Need help?
General
