FEED-COVER PLATE
The feed-cover plate which allows free
fabric movement is used for darning
(page 43), embroidery and button sew
ing (page 27). By covering the feed
with the feed-cover plate the fabric is
not moveable.
CHANGING NEEDLE PLATE
• Raise presser foot. (You do not need
to remove the foot.)
• Turn hand wheel toward you until
needle is in its highest position.
• Open slide plate with downward finger
pressure.
• Place thumb under needle plate and
draw plate to the right to remove.
• Insert new needle plate under locking
pin and over positioning pin.
• Close slide plate.
CHANGING PRESSER FEET
The presser feet that are supplied with
your machine snap on and off a common
shank. To change the foot:
9 Raise presser-foot lifter and turn hand
wheel toward you to raise needle to Its
highest position.
» Press toe of presser foot upward (as
far as it will go) and then snap down
to remove the foot.
• Center the new presser foot under the
shank and lower the presser-foot lifter
so that shank fits over the presser-foot
pin.
• Press down on presser-foot screw until
foot snaps into place.
Changing Needle Plate
Changing Presser Foot
Instrukcje obsługi maszyn do szycia firm Polskich jak i zagranicznych np. Singer Toyota Pfaff Gritzner Łucznik Arka
maszynykrawieckie.shophurt.pl
To Next Page
Loading...
