EasyManua.ls Logo

Singer 252 User Manual

Singer 252
55 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Service
Manual
Registered Trademark
FORM
723
(1172)
SINGER*
SINGER
FACTORY
-
MONZA
Series
Machine
Class
The
Singer
Company
C)
1972
Si
nger
Monza
All
rights reserved
Question and Answer IconNeed help?

Do you have a question about the Singer 252 and is the answer not in the manual?

Singer 252 Specifications

General IconGeneral
BrandSinger
Model252
CategorySewing Machine
LanguageEnglish

Summary

Lubrication Procedures

Presser Foot Pressure Regulator

Adjustment of Presser Foot Pressure

Steps to check and set the correct presser foot pressure for optimal sewing performance.

Presser Bar Assembly

Adjustments - Presser Foot Height

Steps to check and set the correct presser foot height.

Needle Bar

Adjustments of Needle Bar Height

Steps to check and set the correct height of the needle bar.

Needle Bar Bearings

Adjustments of Needle Bar Bearings

Steps to adjust the needle bar bearings for smooth operation.

Needle Bar Vibrating Bracket

Adjustment of Needle Bar Settings

Adjusting front-to-back and sideways movement of the needle bar.

Needle Thread Take-Up and Needle Bar Connecting Link

Needle Thread Tension

Adjustments of Needle Thread Tension

Instructions for adjusting the check spring stop and check spring tension.

Stitch Width Regulator (252-257)

Adjustment of Bight Stops

Setting the stops for straight stitch and maximum stitch width bight.

Sideways Adjustment of Needle Bar

Adjusting the needle bar for correct sideways centering.

Needle Position and Cam Follower Mechanism

Lateral Adjustment of Needle Position

Adjusting the needle's lateral position using the cam follower mechanism.

Cam Stack and Shaft (252-257)

Gear Mesh Adjustment

Adjusting the gear mesh for smooth operation of the cam stack shaft.

Pendulum Timing Adjustment

Setting the correct timing for the pendulum movement of the needle bar.

Hand Wheel and Stop Motion

Bobbin Winder

Adjustment of Winding Limit Stop

Setting the bobbin winder to automatically stop when the bobbin is full.

Horizontal Arm Shaft

Vertical Arm Shaft

Stitch Length Regulator and Feed Fork

Feed Actuating Rod

Rotating Hook

Adjustment of Hook Timing

Setting the correct timing for the rotating hook relative to the needle.

Adjustment of Hook Point to Needle Distance

Setting the precise gap between the hook point and the needle.

Hook Drive Belt

Feed Mechanism - Feed Lift Shaft - Actuating Shaft

Related product manuals