Singer 2802 - Page 13

Service Manual
12
Rev. n . o
Bed Bottom Cover (Free Arm)
Removal:
Replacement:
1. Remove arm top cover.
2. Remove screw (A).
3. Hold the bottom side of cover (B) and pull it out and up from machine.
1. Replacement of this cover is the same as described above, but in a reverse order.
End Cover
Bed Bottom Cover (Flat Bed)
Removal:
Replacement:
1. Remove the four screws (G).
2. Remove bed bottom cover (H).
Replacement of this bed bottom cover is the same as described above, but in a
reverse order.
1.
358487-001 Mar./2005
Removal:
Replacement:
1. Remove the bed bottom rubber feet (C).
2. Remove the screws (D).
3. Remove 8mm hex nut (E).
4. Remove bed bottom cover (F).
Replacement of this bed bottom cover is the same as described above, but in a
reverse order.
1.