Service Manual
Removal:
Replacement:
1. Remove the face plate and arm top cover.
2. Remove needle by loosing the screw (B). Turn handwheel to bring the needle bar to its
position. Loose screw (A) together with the thread guide and then, remove the entire
needle clamp body. Remove also the needle bar gib (C).
3. Loosen needle bar connecting stud screw (D).
4. Draw needle bar (E) up and out of the machine.
Replacement the needle bar the same way as described above, but in a reverse order.
2- Adjust needle bar height (see pages 62-63).
1.
Needle Bar
14
Rev. n .
o
358487-001 Mar./2005
To Next Page
Loading...
