Removal:
Replacement:
1- Remove the face plate cover and arm top cover.
2- Turn hand wheel sufficiently to appear the screw (A). Loosen it. Turn again to
appear the screw (B). Loosen it also.
3- Slide take-up lever assembly (C), take-up stud (D) and needle bar connecting link (E).
1- Replacement is the same as removal in reverse order. Make sure that stud (D) is
firmly located against link (E).
2- Adjust needle location in the needle plate slot (See pages 68-69) and needle to
hook relationship (See pages 70-71).
3- Check hook timing (See pages 80-81), needle bar height (See pages 62-63) and
adjust if necessary.
4- Adjust presser bar alignment and height. (See pages 76-77)
Take-up Lever Assembly and
Needle Bar Connecting Link
Service Manual
18
Rev. n .
o
358487-001 Mar./2005
To Next Page
Loading...
