Service Manual
20
Rev. n .
o
Hand Wheel and Shaft Driver Assembly
Removal:
Replacement:
1. Remove arm top cover and right side cover.
2. Remove the hand wheel (A) by pulling it out from machine.
3. Remove the shaft pin (B).
4. Remove retaining ring (C) and washer (D) from shaft.
5. Remove the hand wheel pulley (E), the timing belt (F), the spring (G) and the hand
wheel connecting bracket (H).
1. Replacement of the hand wheel is the same as described above, but in a reverse
order.
358487-001 Mar./2005
To Next Page
Loading...
