Service Manual
Removal:
Replacement:
1. Remove the free-arm extension table, all the covers, disc stack shaft gear bracket, disc
follower quick out lever and disc follower.
2. Turn the pattern selector dial bringing to sight the screw (A) an then remove this screw.
3. Once again turn the pattern selector dial to bring to sight the screw (B). Remove this
screw too.
5. Remove the pattern selector dial/mechanism (C).
1. Replacement is the same as removal, but in a reverse order.
Pattern Selector Assembly
28
Rev. n .
o
Except 2802/2852
358487-001 Mar./2005
To Next Page
Loading...
