Service Manual
Check:
Adjustment:
1. Set the machine for zigzag.
2. Rotate handwheel to make needle penetrate on both left and right sides of a paper;
than measure the distance between the holes are to be 5,6 to 6,0 mm.
3. If the distance it is wrong, adjust.
1. Remove the arm top cover.
2. Loose stop screw (A).
3. Rotate bracket stop (B) clockwise to increase the width or counterclockwise to
decrease the width.
4. Tighten bracket stop set screw (A).
5. Recheck and readjust if necessary.
Maximum Width Zigzag Lever
Bight Stop
73
Rev. n .
o
Except 2808/2858
358487-001 Mar./2005
To Next Page
Loading...
