Singer 2802 - Page 80

Service Manual
Check:
Adjustment:
1. The hook drive belt tension should be such that a weight of 140 g (5 oz.) centrally
located between the pulleys, deflects the belt 8,6 mm - 10,2 mm (.338” - .400”).
1. Remove free arm extension table, bed bottom cover and extension table bottom cover.
2. Loosen screw (A) and slide belt tensioner (B) up or down until correct tension is
achieved.
3. Tighten screw (A).
Hook Drive Belt Tension
79
Rev. n . o
358487-001 Mar./2005