Service Manual
Removal:
Replacement:
1. Remove the free arm extension table, bed bottom cover, extension table bottom cover,
arm top cover, right side cover and the hand wheel (see pages 19-20).
2. Remove screw nut ( I ) and the eccentric screw (H).
3. Position the top of the eccentric gear(C) at the back of the machine
4. Turn shaft (E) counterclockwise until stitch regulator stroke (B) is in the vertical position
and keep it in that position
5. Remove the spring (A) and fork (B) by pushing it down
1. Replacement is the same as removal in reverse order.
2. Adjust feed dog throw.(See pages 94-95)
Feed Forked Connection
40
Rev. n .
o
358487-001 Mar./2005
To Next Page
Loading...
