16
Head end assembly
Service Manual
Removal:
1- Remove the face plate cover and arm top cover.
2- Remove the lamp socket.
3- Loosen screw (A).
4- Raise presser bar.
5- Loosen presser foot screw (B) and remove shank (G) and presser foot (C) .
6- Remove three screws and washers (D), (E) and (F) .
7- Remove head end assembly.
Replacement:
1- Replacement is the same as removal in reverse order.
2- Adjust needle location in the needle plate slot and needle to hook relationship. (See
pages 75-76)
3- Check hook timing (See pages 91-92) and needle bar height (See pages 67-69) and adjust
if necessary.
4- Adjust presser bar alignment and height. (See pages 87-88)
P/N 358426002
MAR/05
Rev. no.
To Next Page
Loading...
