42
Service Manual
Removal:
1. Remove the free arm extension table, bed bottom cover, extension table bottom cover,
needle plate, feed dog, feed lifting lever assembly (N), pulley (K), and belt (M)
2. Remove eccentric hinge screw nut (H) and eccentric hinge screw (1).
3. Remove screws (F) and (L) and clamps (G) and (A).
4. Remove feed rock shaft assembly (J) with rock shaft center (B) and (E)
Replacement:
1. Replace feed rock shaft assembly (J), left and right centers (B) and (E) with washers (C)
and (D) and clamps (A) and (G).
2. Tighten clamp screws (F) and (L).
3. Replace the feed lifting assembly and feed dog.
4. Replace eccentric hinge screw ( I ) and hinge screw nut (H). Tighten nut (H) to finger
tightness.
5. Adjust feed dog centralization and feed rock shaft end play. (See pages 101 to 104).
6. Adjust feed dog height.(See pages 103-104).
7. Adjust feed dog throw.(See pages 105-106).
8. Replace pulley (K) and belt (M).
9. Adjust hook timing. (See pages 91-92).
10. Replace all covers.
Feed rock shaft assembly
P/N 358426002
MAR/05
Rev. no.
To Next Page
Loading...
