22
Service Manual
Hand Wheel and Shaft Driver Assembly
Removal:
1. Remove arm top cover and right side cover.
2. Remove the hand wheel by pulling it from stud (A).
3. Remove the hand wheel by pulling it out from machine.
4. Remove the shaft stud (A).
5. Remove retaining ring (B) and washer (G) from shaft.
6. Remove the hand wheel pulley (C), the timing belt (D), the spring (E) andf the hand
wheel connecting bracket (F).
Replacement:
1. Replacement of the hand wheel is the same as described above, but in a reverse
order.
P/N 358426002
MAR/05
Rev. no.
To Next Page
Loading...
