32
Service Manual
Removal:
1. Remove arm top cover.
2. Set stitch length control dial to flexi stitch (the mark on the dial aligned with the dot in
the machine casting)
3. Remove spring (A).
4. Set stitch length control dial to "5".
5. Remove the ring (G) and then the cam follower assembly (B).
6. Remove screws (C).
7. Remove cam control feed mechanism (D).
Replacement:
1- Replacement is the same as removal in reverse order.
Caution:
When replacing the cam control feed mechanism, make sure bracket (E) straddles lever (F).
Readjust the flexi-stitch balance if necessary (see pages 115-116).
Cam controlled feed mechanism
(except models 9850 and 9852)
P/N 358426002
MAR/05
Rev. no.
To Next Page
Loading...
